Cannot Ping The Device - Toshiba e-studio 3511 Network Administrator's Manual

Multifunctional digital systems
Hide thumbs Also See for e-studio 3511:
Table of Contents

Advertisement

Cannot Ping the Device

Problem Description
If this equipment does not respond when you ping it, there is a problem either with the network
configuration or with device operation.
The following checklist helps you identify the source of the error and directs you where you can
find more information about resolving it. If the problem persists after you have followed all of
the steps, contact your authorized dealer for further assistance.
194
No Check...
1
Confirm that the TCP/IP pro-
tocol suite is installed on the
client computer.
2
Look at the NIC configura-
tion page and confirm the
TCP/IP settings are correct. Is
the IP Address entered and
valid? Are the Gateway and
Subnet settings correct?
3
Reboot this equipment.
Check the NIC Configura-
tion page that prints out. Are
the TCP/IP settings correct?
4
Try to ping this equipment
again. Did this equipment
respond to the ping?
5
Can you ping this equipment
from any other computer
within the same network? If
not, this equipment might
have an IP Address that is out
of range or invalid.
6
Can you ping to another com-
puter within the same net-
work?
7
If you have customized the
device name, you can check
if the NIC is functional by
restoring the default set-
tings. When this equipment
automatically reboots and a
NIC Configuration page
prints, does the device name
include the NIC's Unit Serial
Number?
Yes
Next Step
Next Step
Next Step
Next Step
End
Next Step
Next Step
Next Step
Network Administrator's Guide — Troubleshooting Overview
No
For Instruction, Go To...
The networking section of your
operating system documentation.
Enter the correct TCP/IP settings.
P.53 "Setting up the TCP/IP"
The settings are not binding, con-
tact your service representative.
Contact your local network spe-
cialist for a valid IP address for
this equipment.
Check the computer's protocol
settings to make sure the gateway
and subnet settings are correct.
The NIC is faulty or improperly
installed. Contact your service
representative.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents