Checking The Front Brake Pads; Checking The Brake Shoes; Bleeding The Hydraulic Brake System - Yamaha MBK YQ100 Service Manual

CHECKING THE FRONT BRAKE PADS/

CHECKING THE BRAKE SHOES/

BLEEDING THE HYDRAULIC BRAKE SYSTEM

EAS00123
CHECKING THE FRONT BRAKE PADS
The following procedure applies to all of the
brake pads.
1.Operate the brake.
2.Check:
• brake pad
Out of specification → Replace.
NOTE:
Replace the brake pad and spring as a set when
replacing the brake pads.
Wear limit
Refer to "FRONT BRAKE" in chapter 6.
EAS00126
CHECKING THE BRAKE SHOES
1.Operate the brake.
2.Check:
• wear indicator
Reaches the wear limit line
brake shoes as a set.
Refer to "REAR WHEEL" in chapter 6.
EAS00133
BLEEDING THE HYDRAULIC BRAKE
SYSTEM
1.Bleed:
• brake fluid.
a.Add proper brake fluid into the reservoir.
b.Install the diaphragm. Be careful not to spill
any fluid or allow the reservoir overflow.
c. Connect a clear plastic tube
caliper bleed screw.
d.Place the other end of the tube into a container.
e.Slowly apply the brake lever several times.
f. Pull the lever as far as possible and hold it
there.
g.Loosen the bleed screw and pull the lever all
the way.
h.When the lever is completely pulled, tighten
the bleed screw, then release the lever.
346002(a)
3-21
INSP
REG
:
0.5 mm
→ Replace the
tightly to the