Brake Pads Replacement - Yamaha MBK YQ100 Service Manual

FRONT BRAKE

BRAKE PADS REPLACEMENT

NOTE:
It is not necessary to disassemble the brake
caliper and brake hose to replace the brake
pads.
1.Remove:
• Brake pads
NOTE:
• Do not depress the brake lever when the
wheel is off the scooter otherwise the brake
pads will be forced shut.
• Install new brake pad springs when the brake
pads have to be replaced.
• Replace the pads as a set if either is found to
be worn to the wear limit @.
2.Push the caliper piston into the brake caliper
by finger.
@
CAUTION:
When pushing the caliper piston into the
brake caliper, brake fluid level in reservoir
tank is increasing higher.
3.Install:
• Brake pads
• Pad spring
4.Inspect:
• Brake fluid level
Refer to "CHECKING THE BRAKE FLUID
LEVEL" section in Chapter 3.
5.Check:
• Brake lever operation
Soft spongy feeling - Bleed the brake system.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" section in Chapter 3.
6-18
CHAS
Wear limit @:
0.5 mm