REED VALVE
YP600051
CHECKING THE REED VALVE
1.Inspect :
• Caburetor joint
Damage/Cracks → Replace.
• Reed valve
Fatigue/Cracks → Replace.
*****************************************************
Inspection steps :
• Visually inspect the reed valve.
NOTE:
Correct reed valve should fit flush or nearly flush
against valve seat.
• If in doubt as to sealing ability, apply suction to
carburetor side of assembly.
• Leakage should be slight to moderate.
*****************************************************
2.Measure :
• Valve stopper height
Out of specification → Replace valve stopper.
322023
3.Measure :
• Reed valve clearance
Out of specification → Replace reed valve.
322024
INSTALLING THE REED VALVE
Reserve the removal procedure.
Note the following points.
1. Install :
• Gasket
2.Tighten :
• Reed valve securing bolts
NOTE:
Tighten the bolts gradually to avoid warping.
5-9
CARB
Valve stopper height
6.0 ~ 6.4 mm
Reed valve clearance
Less than 0.2 mm
11Nm (1.1 m•kg)
:
: