Using A Ground Block; Connecting Power; Led Sequence - Avaya G350 Quick Start For Hardware Installation

Power Up

Using a Ground Block

A ground block might be provided for use with multiple Media Gateway installations. Usually, the customer
electrician mounts the ground block.
To attach the supplementary ground conductor (that is already attached to the grounding screw on the
chassis) to a ground block:
1. Cut the supplementary ground conductor to the length needed to terminate the conductor into one
of the terminals of the ground block. Do not coil the supplementary ground conductor.
2. Attach one end of the remaining 10 AWG (4 mm
block and the other end to an approved ground. Cut this ground wire to the length needed to reach the
approved ground. Do not coil this wire.

Connecting Power

1. Connect the AC power cable to the inlet receptacle on the rear of the chassis.
2. Connect the other end of the power cable into a mains socket.

LED Sequence

When you turn on the G350, the following LED sequence occurs:
1. The PWR LED on the front panel lights.
2. The CPU LED lights if the firmware is running.
3. At least one LED on each media module lights initially and then goes off after about 20 seconds.
20 Quick Start for Hardware Installation: Avaya G350 Media Gateway
2
) ground wire to one of the terminals in the ground