Using Effect Return Signals As Analog Inputs - Akai DPS12 Operator's Manual

5. If necessary, move the cursor to the parameter you wish to adjust in field 2, and turn the [JOG] dial
to set the value.
TIPS :
• The parameters of some effect types are displayed over two screens. In this case, press the
in the first screen to recall the second screen. Press the
• Some effect types require you to switch between different effects manually. If you have selected one of
these types, use the
CLOSE
6. Press the [F5] key to complete the effect settings and return to normal Mixer mode.

Using effect return signals as analog inputs

You can use the effect return signals from EFFECT A and B as analog inputs 3–6 in Assign mode so that they can
be input to the mixer section. Follow the steps below.
1. While the transport section is stopped, press the [ASSIGN] key to recall Assign mode.
FX RTN
2. Press the [F1] key.
The following screen appears.
3. Turn the [JOG] dial and select
to switch analog inputs to effect return signals.
There are three options for this field as follows.
NOTE : Depending on the EFFECT RETURN setting, the indication on the THRU screen and the
SOURCE screen will change.
If you have selected
RTN-L Analog in-6
and
ANALOG IN-5
changes to
If you have selected
RTN-L Analog in-4
,
FXB RTN-R
to in the THRU screen. Also in the SOURCE screen,
RTN-L ANALOG IN-4
,
IN-6 FXB RTN-R
to
MANUAL
key to switch the effects.
[F6]
1 MIXED STEREO
1 MIXED STEREO
for the
FX RTN-R
changes to
FX RTN-L
and
2 STEREO PAIRS
for the Return select field,
FXA RTN-R
changes to
FXA RTN-R
changes to
.
BACK
key to return to the first screen.
[F6]
2 STEREO PAIRS
or
Return select
field,
in the THRU screen. Also in the SOURCE screen,
ANALOG IN-6
changes to
Analog in-3
Analog in-5 FXB RTN-L
, to
ANALOG IN-3
ANALOG IN-5
, to
Chapter 13: Using the effects
MORE
for the method by which
Analog in-5
changes to
FX RTN-R
.
FXA
changes to
Analog in-6
, and
changes to
FXB RTN-L ANALOG
, and
[F6] key
FX
FXA
121