Recording And Playing Back A Scene Memory Of The Mix Parameters - Akai DPS12 Operator's Manual

Recording and playing back a scene memory of the mix parameters

The DPS12 can transmit and receive a mix scene memory (mix parameter settings) as a series of MIDI Control
Change messages. If you record this scene memory to a MIDI sequencer, you can play back the same mix settings
each time you play the MIDI sequencer.
1. Use MIDI cables to connect the MIDI IN/OUT jacks of the DPS12 to the MIDI OUT/IN jacks of a
MIDI sequencer.
Make sure that the
TIP :
2. Create a mix to be recorded as a scene memory, while playing the DPS12.
SELECT
3. Use the
parameters.
4. Move the cursor to the Control via MIDI field, then turn the [JOG] dial to select a MIDI channel
that transmits Control Change messages.
5. In the same manner, move the cursor to the Tx mixer changes: field, then turn the [JOG] dial to
select a MIDI channel that receives Control Change messages.
If the Control via MIDI field and Tx mixer changes: field are set to OFF , Control Change messages are
not transmitted or received.
6. Set the MIDI sequencer so that it will record Control Change messages transmitted from the DPS12.
TIP : At this time, turn off the MIDI thru function of the MIDI sequencer (the function that allows MIDI
messages received at the MIDI IN jack to be output from the MIDI OUT jack unaltered).
MIDI
IN
INPUT
INPUT GAIN
DPS12
Out/Thru:
field is set to
SELECT
π[F1] key or the
Control Change
Control Change
MIDI OUT/
THRU
dps12
DIGITAL PERSONAL STUDIO
OUT
in the MIDI Control Panel.
† [F2] key in Mixer mode to recall the MIDI CONTROL
Chapter 12: MIDI applications
MIDI MIDI
IN OUT
MIDI sequencer
115