Replacing Heel Loops - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.
FIGURE 10.3 Adjusting Footrest Height - On PH93M2 And PHAL4A Front Riggings

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 10.4.
1. Note the position of hex bolt, coved washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
3. Remove the lower footrest.
4. Remove the mounting bolt, spacer and locknut that secure the existing heel loop to the
lower footrest.
5. Slide the existing heel loop off the lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
NOTE: When securing heel loop to lower footrest, tighten the mounting screw and locknut until
the spacer is secure.
Part No 1122147
Footrest Support
Lug Bolt
Locknut
Coved Washer
Lower Footrest
FIGURE 10.4 Replacing Heel Loops
SECTION 10—FRONT RIGGINGS
Locknut
Footrest Support
Hex Bolt
Mounting Bolt
Spacer
Heel Loop
Locknut
61
Pronto
Lower Footrest
® ™
M71 Jr. with SureStep
®