Speed Control Knob; Joystick; Drive Select Toggle Switch - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

Charger/Programming Input
(Front of Joystick)

Drive Select Toggle Switch

Programmable
Mono Port 1/2 or
External Mode
Switch
FIGURE 5.5 MPJ+ Joystick Switches and Indicators
Speed Control
The speed control knob is located on the side of the joystick housing.
1. Rotate the knob clockwise (forward) to increase the speed of the wheelchair to the
programmed max speed.
2. Rotate the knob counterclockwise (backward) to decrease the speed of the wheelchair
to the programmed max speed.

Joystick

The joystick has proportional drive control, meaning that the further the joystick is
pushed from the upright (neutral) position, the faster the wheelchair or seat moves. Your
top speed, however, is limited by the programmed settings.
To slow the wheelchair to a stop, simply release the joystick. The wheelchair has
automatic speed and direction compensation to minimize corrections.
Charger/Programming Input
The charger/programming input is located at the front of the joystick housing. This
provides easy access for charging the wheelchair batteries. This port also serves as the
Remote Programmer Communication connection. Driving is prevented while the system
is charging.
LCD Display Screens
The LCD Display is located in front of the joystick and provides information on the status
of the wheelchair through a backlit display. The LCD display is readable in both bright
sunlight and complete darkness.
Part No 1122147
Memory Card Slot
Joystick
37
SECTION 5—WHEELCHAIR OPERATION
LCD Display
Mode Switch

Speed Control Knob

Remote
On/Off
Input
To Controller
®
Pronto
™ ®
M71 Jr. with SureStep