Table of Contents
Advertisement
Invacare® Formula™ CG Seating
7.7.2 Removing
1.
Push the legrest release handle F toward the inside of the
wheelchair (facing the front of the wheelchair) and swing the
legrest to the outside of the wheelchair.
Lift up on the legrest A and remove from the wheelchair.
2.
3.
Repeat STEPS 1- 2 for opposite side of wheelchair.
7.8 Replacing Heel Loops
Note the position of hex bolt A, coved washers B and locknut
1.
C for reinstallation.
2.
Remove the hex bolt, coved washers and locknut that secure the
lower footrest D to the footrest support E.
3.
Remove the lower footrest.
4.
Remove the phillips bolt F, spacer G and locknut H that secure
the existing heel loop I to the lower footrest.
5.
Slide the existing heel loop off the lower footrest.
6.
Replace heel loop.
7.
Reverse STEPS 1-6 to reassemble.
54
When securing heel loop to lower footrest, tighten the
mounting screw and locknut until the spacer is secure.
7.9 Removing/Installing the Manual Center
Mount Footrest
7.9.1 Installing
1.
Engage the release lever with one hand, hold the center mount
footrest B with the other, and insert the center mount footrest
into the mounting bracket C of the seat frame D.
Reinstall the rigging pivot pin A to secure the center mount
2.
footrest to the mounting bracket of the seat frame.
7.9.2 Removing
Release lever is not shown. It is located towards the front
or center of seat frame.
1143155-R-01
Advertisement
Table of Contents
