Removing The Batteries - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 14—TRANSPORTING THE WHEELCHAIR
When flipping back the seat, be sure to maintain a grip on the seat so it does not flip
over the back of the base frame - otherwise damage to the wheelchair may result.
2. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 45.
3. While standing at the rear of the wheelchair base, disconnect the left motor connector
from the controller and insert the motor connector into the opening in the side shroud
behind the left motor release lever.
4. Disconnect the right motor connector from the controller and insert the motor
connector into the opening in the side shroud behind the right motor release lever.

Removing the Batteries

5. Disconnect the rear battery from the front battery (GREY connectors).
6. Disconnect the front battery from the controller (RED connector).
7. Unlatch the battery tie-down strap (not shown).
8. Remove the rear battery and place on the ground away from the wheelchair base.
9. Slide the front battery rearward then remove and place on the ground away from the
wheelchair base.
® ™
Pronto M71 Jr. with SureStep
CAUTION
® 88
Part No 1122147