Section 11-Shroud/Wheels; Replacing Foam Filled Or Pneumatic Tires Onto Wheel Rim; Removing/Installing Shrouds; Removing - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 11—SHROUD/WHEELS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, verify that on/off switch
on the joystick is in the off position.
Replacing Foam Filled or Pneumatic Tires Onto Wheel
Rim
DO NOT attempt to replace foam filled or pneumatic tires. This procedure MUST
be performed by a qualified technician.
NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat
spots will vanish with continued use of the wheelchair.

Removing/Installing Shrouds

NOTE: For this procedure, refer to FIGURE 11.1 on page 68.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 85.
2. Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on
page 45.
3. Perform one of the following:
• Right and Left Side Shroud - Remove the five mounting screws that secure each
shroud to the base frame. Refer to Detail "A" of FIGURE 11.1.
NOTE: The shorter mounting screws are used to secure the top rear of side shrouds. Refer to Detail
"A" of FIGURE 11.1.
• Front Shroud - Remove the two mounting screws that secure the front shroud to
the base frame. Refer to Detail "B" of FIGURE 11.1.
• Rear Shroud - Remove the two mounting screws that secure the rear shroud to the
base frame. Refer to Detail "B" of FIGURE 11.1.
4. Lift the shrouds off of the wheelchair frame.
Part No 1122147
SECTION 11—SHROUD/WHEELS
WARNING
WARNING
67 ® ™
Pronto M71 Jr. with SureStep
®