Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 6.4.
1. Note the position of hex bolt, coved
washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips bolt, spacer and
locknut that secure the existing heel
loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the
spacer is secure.
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE 6.5.
1. Perform one (1) of the following:
• Raising - Pull back on the release lever and raise front rigging to the desired height.
• Lowering - Support front rigging with one (1) hand away from the release lever.
Push release lever downward with other hand.
FIGURE 6.5 Raising/Lowering Elevating Front Riggings
Part No. 1125038
SECTION 6—FRONT RIGGINGS
Locknut
Coved
Washer
Footrest
Support
Lower
Footrest
FIGURE 6.4 Replacing Heel Loops
Release
Lever
57
Coved
Washer
Hex Bolt
Phillips Bolt
Spacer
Heel Loop
Locknut
®
Pronto
M91 and M94
™