Removing; Replacing Heel Loops; Removing/Installing The Manual Center Mount Footrest; Installing - Invacare ASBA User Manual

7.9.2 Removing

1. Push the legrest release handle F toward the inside of the
wheelchair (facing the front of the wheelchair) and swing the
legrest to the outside of the wheelchair.
Lift up on the legrest A and remove from the wheelchair.
2.
3. Repeat STEPS 1- 2 for opposite side of wheelchair.

7.10 Replacing Heel Loops

Note the position of hex bolt A, coved washers B and locknut
1.
C for reinstallation.
2. Remove the hex bolt, coved washers and locknut that secure the
lower footrest D to the footrest support E.
3. Remove the lower footrest.
Remove the phillips bolt F, spacer G and locknut H that secure
4.
the existing heel loop I to the lower footrest.
5. Slide the existing heel loop off the lower footrest.
1143192-L-03
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
When securing heel loop to lower footrest, tighten the
phillips screw and locknut until the spacer is secure.
7.11 Removing/Installing the Manual Center
Mount Footrest

7.11.1 Installing

1. Engage the release lever with one hand, hold the center mount
footrest B with the other, and insert the center mount footrest
into the mounting bracket C of the seat frame D.
Reinstall the rigging pivot pin A to secure the center mount
2.
footrest to the mounting bracket of the seat frame.
Setup Maintenance
37