Adjusting Height - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 10—FRONT RIGGINGS
DETAIL "A" - REMOVING/INSTALLING
Seat Frame
Mounting
Bracket on
Seat Frame
Center
Mount
Footrest
FIGURE 10.7 Removing/Installing/Adjusting Center Mount Adjustable Knee Angle Footrest

Adjusting Height

While the wheelchair is moving, minimum ground clearance for the front rigging is
two inches. If the wheelchair is not moving, the front rigging MUST maintain a min-
imum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to Detail "B" of FIGURE 10.7 on page 64.
1. Remove the two mounting screws that secure the footrest extension tube to the
extension tube housing.
2. Adjust the footrest extension tube to the desired height and align the corresponding
holes to the mounting holes on the extension tube housing.
3. Reinstall the two mounting screws to secure the footrest extension tube to the
extension tube housing. Securely tighten.
4. Repeat STEPS 1-3 for the other extension tube.
® ™
Pronto M71 Jr. with SureStep
Extension Tube
Rigging
Mounting Holes
Pivot Pin
Release
Height Adjustment
Lever
WARNING
® 64
DETAIL "B" - ADJUSTING HEIGHT
Seat Frame
Mounting
Screws
Holes
Release
Lever
Extension
Tube
Housing
Extension
Tube
Part No 1122147