Table of Contents
Advertisement
Bar Code/Patch Tone
A-61097
May 1997
NOTE: Patch reading and Bar Code reading must be enabled. In
addition, the confirmation tones must have been enabled during
machine definitions; otherwise, this definition will be ignored.
Enables or disables a confirmation tone issued when a bar code and a
patch are both recognized. The default value is Off or Disabled.
Microimager 70
Scanner 923
1. Select Bar Code/Patch Tone.
Mode Number:
10
Mode Configuration
MODE 10
Mode Name
3 Lvl
Index Format
Supprs
IA Display Format
4233
IA Field Widths
2112
Level Rules
None
Batching
Auto
AEC Mode
Duplex
Film Mode
?????
Reduction Ratio
1 Roll
# of Cassettes
Comic
Film Writer
Off
Image Mgmt Code
Off
Length Monitor
Off
Skew Monitor
Xport
Check Stacker
Off
Endorser
Not Used
Save & End Session
Previous Menu
2. Select the desired status.
NOTE: If either the Patch Detected Tone or Bar Detected Tone is
enabled, the Bar Code/Patch Tone cannot be enabled.
Microimager 70/AFM
Scanner/Microimager 990
Mode Name:
MODE10
Ftswitch Pressed
Undef
Ftswitch Released
Undef
Ftswitch Cnf Tone
Off
Patch Reader 1
Off
Patch Reader 2
Off
Patch Definition
Lvl 2
Bar Code
Off
Confirmation Tone
N N N
OCR Status
Off
COIN User Channel
On
Printer Control
Disply
Primary DP-1
Off
Secondary DP-1
Off
Doc. Printer 12
Off
Document Sorter
Off
Mode Overrides
No Sav
Film Definition
F
Don't Save & End Session
End Configuration
Scanner 900
Scanner 9500
Confirmation Tone
Patch Detected Tone
Bar Detected Tone
Bar Code/Patch Tone
Previous Menu
BC/Patch Tone
Field
Off or Disabled
On or Enabled
Previous Menu
3-77
Advertisement
Table of Contents
