Line - Kodak 4C8894 Installation Instructions Manual

A-61097 May 1997
1. Select IA Field Widths.
Mode Number: 10
Mode Configuration
MODE 10 Mode Name
3 Lvl Index Format
Supprs IA Display Format
4233 IA Field Widths
2112 Level Rules
None Batching
Auto AEC Mode
Duplex Film Mode
????? Reduction Ratio
1 Roll # of Cassettes
Comic Film Writer
Off Image Mgmt Code
Off Length Monitor
Off Skew Monitor
Xport Check Stacker
Off Endorser
Not Used
Save & End Session
Previous Menu
2. Select the field to be defined.
Mode Number: 10
Mode Configuration
MODE 10 Mode Name
3 Lvl Index Format
Supprs IA Display Format
4233 IA Field Widths
2112 Level Rules
None Batching
Auto AEC Mode
Duplex Film Mode
????? Reduction Ratio
1 Roll # of Cassettes
Comic Film Writer
Off Image Mgmt Code
Off Length Monitor
Off Skew Monitor
Xport Check Stacker
Off Endorser
Not Used
Save & End Session
Previous Menu
3. Select the desired field width for the specified field.
NOTE: If you intend to link the current mode with another mode, the field
width definitions for both modes must be the same.
If you change the field widths a message appears:
To avoid E205 errors at powerup, first save mode programming,
then enter a new IA for mode.
4. Press Enter.
Mode Name: MODE10
Ftswitch Pressed Undef
Ftswitch Released Undef
Ftswitch Cnf Tone Off
Patch Reader 1 Off
Patch Reader 2 Off
Patch Definition Lvl 2
Bar Code Off
Confirmation Tone N N N
OCR Status Off
COIN User Channel On
Printer Control Disply
Primary DP-1 Off
Secondary DP-1 Off
Doc. Printer 12 Off
Document Sorter Off
Mode Overrides No Sav
Film Definition F
Don't Save & End Session
End Configuration
Mode Name: MODE10
Ftswitch Pressed Undef
Ftswitch Released Undef
Ftswitch Cnf Tone Off
Patch Reader 1 Off
Patch Reader 2 Off
Patch Definition Lvl 2
Bar Code Off
Confirmation Tone N N N
OCR Status Off
COIN User Channel On
Printer Control Disply
Primary DP-1 Off
Secondary DP-1 Off
Doc. Printer 12 Off
Document Sorter Off
Mode Overrides No Sav
Film Definition F
Don't Save & End Session
End Configuration
Field Num
Fixed Field
Field A
Field B
Field C
Previous Menu
Field Num
Fixed Field
Field A
Field B
Field C
Previous Menu
Enter Field Width
0 1 2 3 4 5 6 7 8 9
3-9