Table of Contents
Advertisement
6 • Troubleshooting
Problem
INSERTS
Poor Insert Feed
Insert Feeder
side guides set
incorrectly.
Insert Feeder
separator
adjustments
incorrect.
Inserts loaded
incorrectly.
Insert Feeder
Wedge used
incorrectly.
Booklets not
feeding correctly.
Inserts out of
specification.
Inserts won't feed when using Manual Feeder
By default, Insert
Feeder(s) are
disabled in Manual
Feed mode.
6-6
Remedy
Set guides to Insert width and back
off 1/4 turn.
Make sure the two Insert Feeder
adjustments (number and letter
settings) are set correctly for the
type of Insert being run.
Make sure stack has been fanned
before loading.
Changing the orientation of the
Insert stack may help.
Let the Wedge slide down behind
the Insert stack to support it.
Booklets must only be run from
Insert Feeder F.
Check the Mail Piece Icon Tree
loading instructions.
Check specifications in this guide.
A Supervisor can change this
default setting to allow Insert
Feeders to operate in Manual Feed
mode using the Manual Feed
Setup.
Page
3-18
3-18
3-19
3-19
1-15,
3-18
1-12,
1-13
7-4
4-8
SV40221 Rev. C
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
