Other Settings; Running A Trial Piece - Pitney Bowes DI500 Operator's Manual

All of the Linked Feeders must be loaded in the same sequence in
which they become empty, this ensures that the sheets stay in the
correct order.
If the feeders are not loaded in the correct order, the machine will
display the following options:
Exclude
This option allows you to exclude a feeder from a run until
another Job Definition or Trial Piece is selected.
Resolve Feeder (Loadng Error)
This option appears if a feeder has been loaded in an incorrect
sequence. Select Resolve Feeder to find out which feeder was
loaded in the wrong sequence.

Other Settings

If required, reset the item and/or batch counters by pressing the
Reset Counters key.
If necessary, fill the Sealer with sealing solution or water (see page
3-20).
If you are running an Optical Mark Recognition (OMR) job, the OMR
Scanners must be aligned to the OMR marks on the material being
run. Refer to page 5-22 for instructions.
Now run a Trial Piece as described in the following section.

Running a Trial Piece

A Trial Piece is required to enable you to check the Mail Piece
contents and to allow the machine to calibrate itself for the material
being run.
Press the Trial Piece key. The machine runs a single Mail Piece
which exits the machine unsealed so that you can check the
contents. The machine then asks if the Trial Piece is OK.
If the Trial Piece is OK, select Yes and follow the instructions in the
section 'Automatic Processing' on page 3-7.
SV40221 Rev. C
Operator Functions • 3
3-5