Automatic Connection Setup (Hotline); Reserve Trunk; Assigning A Station Number (Not For U.s.) - Siemens HiPath 3000 Operating Instructions Manual

Step by Step

Automatic Connection Setup (Hotline)

If this function is configured (contact the service per-
sonnel), the system automatically sets up a connection
to a preset internal or external destination.
n
Lift the handset.
Depending on the setting, the connection is either set
up immediately or only after a preset period of time
(hotline after a timeout).

Reserve Trunk

If this feature is configured (contact the service person-
nel), you can reserve a busy trunk for your own use.
When the trunk is free, you receive a call.
n
Lift the handset.
o
Enter the external code. The external trunk is busy; you
hear a busy signal tone. Wait about 5 seconds until the
busy tone ends.
The trunk is reserved.
t
Replace the handset.
When the reserved trunk becomes free:
Your telephone rings.
n
Lift the handset. You hear the CO dial tone.
o
Enter the number of the external station.

Assigning a Station Number (Not for U.S.)

If this function has been configured (contact the service
personnel), you can selectively assign a specific
number (DID number) to your telephone before making
an external call. The assigned number then appears on
the called party's display.
n
Lift the handset.
qhe
Enter the code.
o
Enter the DID number you wish to use.
o
Dial the external number.
Making Calls – Convenience Functions
21