Installation; Mount Rim Exit Device And Outside Lever Trim - Kaba Mas High Security Pedestrian Exit Device with Electric Locking Trim Installation Manual

Installation

Mount Rim Exit Device and Outside Lever Trim

1. Insert Rim Cylinder into trim plate and secure on opposite
side of trim with mounting bracket and two screws as
shown in Figure 11. Tighten screws securely.
Note: The Rim Cylinder Mounting Screws may need to be
shortened. You may discard the mounting plate that
was included with the Rim Cylinder as it is not needed
for this installation.
2. Place Outside Lever Trim on door using holes previously
drilled.
3. Throughbolt the Rim Exit Device to the Outside
Lever Trim using four (4) #10-24 x 1" PPHMS
as shown in Figure 12. Do not tighten screws.
4. Locate, mark and drill end cap mounting hole
following these steps:
A. Level the Rim Exit Device
B. Mark the center of the 5/16" diameter hole
at the end of the channel.
C. Drill a 9/32" diameter hole through the door.
D. Drill a 3/8" diameter hole on the trim side
of the door using the 9/32" diameter hole
as a guide.
6. Insert the device channel cover as shown in
Figure 13, with the U-shaped slot toward the
open end.
7. Install the end cap mounting bracket using the
sexbolt and the 1/4"-20 x 3/4" TPHMS mount-
ing screw as shown in Figure 13. Make sure
the Rim Exit Device is level.
Tighten the mounting screw.
8. Tighten all mounting screws and
check for smooth operation.
Figure 11 - Rim Cylinder Mounting
Figure 12 - Mount Rim Exit Device
Through Door to Outside Lever Trim
1/4"-20 X 3/4" TPHMS
MOUNTING SCREW
Figure 13 - Install End Cap Mounting Bracket
Mounting
Bracket
Tailpiece
CHANNEL
COVER
MOUNTING
Rim
Cylinder
SEX
BOLT
BRACKET
13