Kaba Mas High Security Pedestrian Exit Device with Electric Locking Trim Installation Manual page 16

2. If the Rim Exit Device is longer than "X", cut the device.
A. Remove the device channel cover, ro-
tate 180 degrees, and then re-insert it.
(U-shaped slot towards touchbar.)
B. Mark the device channel and channel
cover to length "X".
Note: Be sure channel cover is pushed snug to
touchbar prior to marking or cutting to
size.
C. Cut both device channel and channel cover to
marked dimension and remove burrs.
Note: Factory recommends sawing rather than grind cut
to size. Grinding can damage the finish of the
device and sawing results in less damage to the
device finish.
3. Drill end cap mounting hole in device
channel.
A. Remove the device channel cover
and drill a 5/16" diameter hole on the
device reference centerline 5/16"
from the end of the channel as shown
in Figure 10.
12
Figure 8 - Mark Device Channel and Cover Length
Figure 9 - Cut Device Channel and Cover
Figure 10 - Drill End Cap Mounting Hole in Device Chan-
nel