Connect Cable Assemblies - Kaba Mas High Security Pedestrian Exit Device with Electric Locking Trim Installation Manual

Connect Cable Assemblies

1. Refer to Figure 22 or Figure 23 depending on the handing of your installation. Move the brass nut away
from the open end of the brass threaded plug on the bellcrank cable assembly. Turn the brass threaded
plug into the turnbuckle on the lock cable assembly until approximately half of the threaded plug is
inside the turnbuckle.
2. Do not tighten the brass nut on the threaded plug at this time.
Figure 22 - Connect Lock and Bellcrank Cable
Assemblies - RHR
Figure 23 - Connect Lock and Bellcrank Cable
Assemblies - LHR
27