Table of Contents
Advertisement
Installation Overview
The High Security Pedestrian Exit Device - Electric Trim Version consists of:
1. A Rim Exit Device with Electric Locking Trim and Outside Lever Trim with Rim Cylinder
2. A High Security Pedestrian Door Lock (CDX-09)
3. Interface Hardware, Covers and Cover Brackets
4. A Relatching Delay System (RDS) with power supply and control module
The Installation Guide will describe the steps required to install each of these components of the High
Security Pedestrian Exit Device.
Basic Tools and Materials Needed
Before beginning installation, be certain that you have the following tools readily available:
•
Measuring tape
•
Level
•
Combination square
•
Tape
•
Hammer
•
Center punch
•
Electric hand drill
•
1/4" drill bit
•
9/32" drill bit
•
5/16" drill bit
•
3/8" drill bit
•
1/2" drill bit
•
No. 25 drill bit
•
2" hole saw with 1/4" pilot
•
1 1/4" hole saw with 1/4" pilot
•
Long nose pliers
•
Pliers
•
3/4" end wrench
•
1/4" end wrench
•
Hacksaw
•
File
•
1/4" or smaller slotted head screwdriver
•
#1 Phillips head screwdriver
•
#3 Phillips head screwdriver
•
#1 Phillips head stubby screwdriver
•
Safety glasses
Other tools that may be required:
•
#10-24 Screw cutter
•
External snap ring pliers
For a metal door installation, the following tools are needed:
•
Tap handle
•
#10-24 tap
•
#10-32 tap
I
NTRODUCTION
1
Advertisement
Table of Contents
