Step 7: Installing The Wing - Global Hobby Wattage Sky Wizard Instruction Manual

Step 7: Installing the Wing

Push the propeller firmly onto the motor shaft.
When pushing the propeller into place, support the
back of the motor with your fingers.
Set the wing onto the fuselage.
Line up the two molded dots in the middle of the wing
with the molded centerline in the fuselage.
Install the rubber bands to hold the wing firmly in
place.
Use two rubber bands per side (four total) to hold the
wing in place.
It is not necessary to use more than four rubber
bands, but if you use less, the wing may move during
flight, resulting in poor flight performance.
Continued on Next Page
11