Section 4: Assembling Your Air Buggy; Step 2: Installing The Transmitter Batteries - Global Hobby Air Buggy 151151 Operating Instructions Manual

SECTION 4: ASSEMBLING YOUR AIR BUGGY

STEP 1: INSTALLING THE TRANSMITTER ANTENNA

STEP 2: INSTALLING THE TRANSMITTER BATTERIES

Push the antenna down into the molded hole in the top
of the transmitter.
Thread the antenna (clockwise) into place and tighten it
gently until it stops.
IMPORTANT Do not force the antenna into place or
tighten it too strongly. Doing so could cause damage to
the antenna and/or transmitter.
Carefully remove the battery cover from the front of the
transmitter by pulling down on it with one hand while
holding the transmitter with your other hand.
Install 6 fresh AA Alkaline batteries, being careful to make
sure that the polarity is correct for each battery.
If you use rechargeable AA NiCD cells,
PRO TIP
double-check to make sure that they are fully charged
before installing them into the transmitter. Never attempt
to charge or recharge Alkaline cells.
After double-checking that the batteries are installed
correctly, reinstall the battery cover, making sure it's firmly
seated into place.
6
Continued On Next Page