Table of Contents
Advertisement
8
Insert the Z-bend in the left wire into the middle hole
in the plastic control horn on the top of the horizontal tail.
You will have to slightly twist the tail and the wire to
easily install the Z-bend.
The plastic control horn should face up toward you.
When installing the Z-bend, make sure the longer
portion of the wire is facing toward the outside edge of
the plastic control horn.
Now insert the Z-bend in the right wire into the middle
hole in the plastic control horn on the right side of the
vertical tail.
You will have to slightly twist the tail and the wire to
easily install the Z-bend.
Note that the longer portion of the Z-bend is toward
the top of the plastic control horn.
Continued on Next Page
Advertisement
Table of Contents
