Global Hobby Wattage Sky Wizard Instruction Manual page 9

Line up the two tail mounting screws with the two
holes in the horizontal tail.
Push the vertical tail down onto the horizontal tail.
Line up the tail mounting screws with the two holes
in the fuselage tube.
Push the tail assembly firmly down into place.
Turn the fuselage over and slide the tail wheel over
the two tail mounting screws.
The tail wheel should point toward the back of the
fuselage tube as shown.
Thread one hex nut onto each mounting screw.
Tighten each hex nut finger-tight.
Use an adjustable wrench to tighten the hex nuts
firmly to draw the tail assembly down into place.
The tail assembly should be firmly tightened down
against the fuselage tube.
9