Global Hobby Wattage Sky Wizard Instruction Manual page 15

Testing the Sky Wizard
Step 1: Adjusting the Control Surfaces
Turn on the transmitter.
Plug in and install the flight battery. Do not press the safety arming switch yet.
Carefully adjust the left and right control trim lever
until it is centered with the marks above and below it.
Carefully adjust the up and down control trim lever
until it is centered with the marks to the right and left of it.
IMPORTANT
Before each flight it's important to check to make sure
that each control surface is exactly even with the tail. If
they are not, the Sky Wizard will not fly properly.
If the control surfaces are not exactly even with the
tail, use your fingers to carefully bend the wire (where it
comes out of the fuselage tube) until the back edge of
each control surface is even with the tail.
Continued on Next Page
15