Srpc-1 - Sony SRPC-1 Operation Manual

2-2 SRPC-1

1 Recorder connector
2 Lock lever
3 Release knob
4 Battery attachment
section
5 AUDIO INPUT CH-3 and
CH-4 connectors and input
selection switches
6 MONITOR OUT L and R
connectors
7 AES/EBU INPUT CH7/8 and CH9/10
connectors
8 AES/EBU OUTPUT CH1-12 connector
a Recorder connector
Connect the SRW-1 HD Portable Digital Recorder.
b Lock lever
After joining the SRW-1 and SRPC-1, rotate this lever to
lock the joint.
c Release knob
When separating the joined SRW-1 and SRPC-1, rotate the
assist lever while pulling out this knob.
Note
Once you have joined the SRW-1 and SRPC-1, do not pull
out the release knob except when you want to detach the
SRW-1 from the SRPC-1 because doing so results in
separation of these units.
w; CAMERA connector
wa POWER indicator
ws Info indicator
9 Assist lever
0 EARPHONES jack and
qa HD SDI OUT A and B
qs HD SDI IN A and B connectors
qd MONITOR OUT HD SDI
qf REF IN HD and SD connectors
qg POWER ON/OFF switch
qh REMOTE IN connector
qj CAMERA REMOTE IN
qk EXT DC SELECT switch
ql DC IN connector
d Battery attachment section
Attach a BP-GL95 Battery Pack or AC-DN10/DN2B AC
Adaptor.
For details, see 3-4 "Power Supply Preparations" (page
35).
e AUDIO INPUT CH-3 and CH-4 (analog audio
input channels 3 and 4) connectors (XLR 3-pin,
female) and input selection switches
These connectors allow up to four channels of analog
audio signals to be input.
Set the input selection switches as follows, depending on
the type and level of the input audio.
LINE: For line input
MIC: For microphone input
+48V ON: For input from microphones with external
power supply
(When optional HKSR-
101 installed)
LEVEL knob
connectors
and SD SDI connectors
connector
2-2 SRPC-1
19