Recording Preparations And Operations; Selecting The Video Input To Record (When Optional Hksr-101 Is Installed); Monitor - Sony SRPC-1 Operation Manual

5-2 Recording
Preparations and
Operations
Before recording, make the following preparations.
About connections for recording, see page 26.
Operation
Select the recording
source input to the
SRPC-1 (when the
optional HKSR-101 is
installed).
Select whether or not
to perform pull-down
conversion for the
output to the HD
a)

monitor.

Select the audio
signals to record.
Make settings for
audio signals to
monitor.
Set the audio level
meter display range.
Set the recording
audio level.
Adjust the level of
audio signals output
to the EARPHONES
jack.
Cancel record inhibit
if the system is set to
record inhibit mode.
Select the type of
time data to display.
Make settings for the
timecode generator
depending on
timecode and user bit
data to record.
a) This selection is possible only when the frame frequency is 23.98PsF.
5-2-1 Selecting the Video Input To
Record (When Optional HKSR-
101 Is Installed)
When the optional HKSR-101 is installed in this unit,
select the input from the CAMERA connector (optical-
64

5-2 Recording Preparations and Operations

Menu item or Reference
control
VIDEO I/O in the Page 64
VIDEO Setup menu
PD(MON) in the Page 64
VIDEO Setup menu
INPUT SEL in the Page 65
AUDIO Setup menu
PHONE SEL in the Page 65
AUDIO Setup menu
METER TYPE in the Page 66
AUDIO Setup menu
REC LEVEL in the Page 66
AUDIO Setup menu
Rotate the LEVEL Page 17
knob of the Page 20
EARPHONES jack.
REC INHI in the Page 69
SYSTEM Setup menu
TIMER SEL in the TC Page 67
Setup menu
RUN MODE, TCG Page 67
MODE, REGENE
SOURCE in the TC
Setup menu
fiber connector) or the input from the HD SDI IN A/B
connectors.
1
Press the menu selection button "VIDEO".
The VIDEO Setup menu appears.
2
Rotate the SELECT/ENTER dial to select "VIDEO I/
O", and press the dial.
A settings window appears.
3
Rotate the SELECT/ENTER dial to select one of the
following, and press the dial.
CAM(Optical): Use the input signal from the
CAMERA connector.
SDI Input: Use the input signal from the HD SDI IN
A/B connectors.
5-2-2 Selecting Signals to Output to
the HD Monitor
Before recording video, first check it on the monitor.
When the frame frequency is 23.98PsF, in the VIDEO
Setup menu, select whether or not to perform pulldown
conversion for the output to the MONITOR OUT HD SDI
connector.
1
Press the menu selection button "VIDEO."
The VIDEO Setup menu appears.
V I D E O S e t u p
PD(MON) AUTO
DC
MON SEL(x2)
VIDEO I/O
LUT(MON)
LEVEL CLIP
C A S S O U T
S RW - 1
2
Rotate the SELECT/ENTER dial to select PD(MON),
then press the dial.
A setting window appears.
3
Rotate the SELECT/ENTER dial to select one of the
following, then press the dial.
AUTO: Pulldown conversion is performed if the
frame frequency is 23.98 Hz. Otherwise pulldown
conversion is not performed.
THRU: Pulldown conversion is not performed.
00:00:00:00
T C R