Auto Timer Rec - Sony SRPC-1 Operation Manual

dB
ANA ANA SDI SDI
0
-10
-20
-30
-60
EMP EMP EMP EMP
PB
L R L R L R L R
1 2 3 4
TCG
00 00
H
13.2V REMAIN
- - -
After about 0.5 seconds of normal tape recording, the
specified number of frames are accumulated in the
memory of the HKSR-102. Recording to tape starts
again when the amount of data reaches the specified
amount. The tally indicator of this unit lights during
storage to memory and during recording to tape.
During Manual Timer Rec recording, each time the
PAUSE button is pressed, the specified number of
frames are accumulated in the memory and the unit is
put into recording standby mode.
To check the amount of data in memory
Press FUNC + HOME twice. The amount appears at
the bottom of the display (see page 77).
To cancel Manual Timer Rec mode
Press the STOP button.
Note
Do not stop recording until the amount of data in memory
exceeds 20%. When there is only a small amount of data in
memory, recording may stop without transferring the
images to tape.

6-2-2 Auto Timer Rec

Note
In the SYSTEM Setup menu, set SELECT FPS to "OFF".
1
In the SYSTEM Setup menu, set EDIT >TIMER REC
to "AUTO".
2
In the submenu window, select "Interval" and then
press the SELECT/ENTER dial.
A setting window opens.
3
Rotate the SELECT/ENTER dial to set the recording
interval (hours/minutes/seconds).
4
In the submenu window, select "Auto Frm" and then
press the SELECT/ENTER dial.
90
6-2 Timer Rec
SDI SDI SDI SDI SDI SDI A/E A/E
EMP EMP EMP EMP EMP EMP EMP EMP
L R L R L R L R L R L R L R L R
5 6 7 8 9 10 11 12
SRW-1
KEYINHI
RECINHI
00 00
M S F
IN: --:--:--:--
LOCAL
M
1080
CH.COND
23.98PsF EE
4:2:2
15:25
A setting window opens.
5
Rotate the SELECT/ENTER dial to specify the
number of frames to record in one take.
6
Put the unit into recording paused mode.
In Auto Timer Rec mode, "T" appears on the HOME
screen before the number of lines of the signal format.
dB
ANA ANA SDI SDI SDI
0
-10
-20
-30
-60
EMP EMP EMP EMP EMP
PB
L R L R L R L R L R
1 2 3 4 5
TCG
00 00
H
13.2V REMAIN CH.COND
- - -
Recording at the specified intervals of specified time
begins, and the specified number of frames are
accumulated in the memory of the HKSR-102.
Recording to tape starts when the amount of data
reaches the specified amount. The tally indicator of
this unit lights during storage to memory and during
recording to tape
To check the amount of data in memory
Press FUNC + HOME twice. The amount appears at
the bottom of the display (see page 77).
Note
Do not stop recording until the amount of data in memory
exceeds 20%. When there is only a small amount of data in
memory, recording may stop without transferring the
images to tape.
SDI SDI SDI SDI SDI A/E A/E
EMP EMP EMP EMP EMP EMP EMP
L R L R L R L R L R L R L R
6 7 8 9 10 11 12
SRW-1
KEYINHI
RECINHI
00 00
M S F
IN: --:--:--:--
LOCAL
T
1080
23.98PsF EE
4:2:2
15:25