Calibrating The Scanner; Using Service Codes - Philips SFF 6135hfd User Manual

Instructions for Cleaning!
DANGER!
Instructions for Cleaning!
Use a soft, lint-free cloth. Never use liquid or
easily flammable cleansers (sprays, abrasives,
polishes, alcohol, etc.). Do not allow any mois-
ture to reach the interior of the device.
Moisten the cloth slightly with cleaning alco-
hol in order to remove stubborn marks. The
cloth must however, never be wet.
Cleaning the Scanner
1. Open the scanner cover.
2. Carefully wipe the scanner glass of the flatbed scan-
ner with a lint-free cloth.
3. Close the scanner cover.
Service · Calibrating the Scanner

Calibrating the Scanner

· Calibrating the Scanner
Calibrating the Scanner
If vertical lines appear on the printed pages or on the fax
messages, it is possible the scanner needs to be calibrat-
ed.
Instructions for Calibrating!
CAUTION!
Instructions for Calibrating!
The scanner is calibrated in the factory and
normally no new calibration is needed. Clean
the the scanner glass and the scanner film first
before calibrating the scanner (see also chap-
ter Cleaning, page 66).
1. Insert a white piece of paper onto the flatbed scan-
ner.
2. Press C, 931 and OK.
3. Confirm with OK.
4. Wait until calibration is completed and the device
returns to starting mode.

Using Service Codes

· Using Service Codes
Introduction
The service codes delete all the changed settings and
your device is reset to factory settings. It may be possi-
ble that the device with the changed settings reacts dif-
ferently than expected.
Using Service Codes
CAUTION!
Settings will be Deleted!
Only use the service codes if this is absolutely
necessary. Some service codes also delete
saved messages and telephone book entries.
1. Press C, 933 and OK.
2. Enter a service code:
70015—Deletes all changed settings.
Saved data and telephone book entries remain in-
tact.
70026—Deletes all queued print jobs,
when there are problems with printing.
70158—Deletes all changed settings
and saved data. The device is reset to factory set-
tings and the initial installation process is started.
3. Confirm with OK.
EN
67