Preventing Condensation; Checking The Interactive Flat Panel Installation; Removing Your Interactive Flat Panel - SMART Board SBID 8055i User Manual

C H A P T E R 7
Maintaining your interactive flat panel

Preventing condensation

Your interactive flat panel screen contains layers of glass that can collect condensation, especially in
the following conditions:
Temperature extremes with high humidity
l
Rapid changes in humidity, which can occur when you operate the product near water, such as a
l
sink, pool, kettle or air conditioner ventilator
Direct exposure to sunlight
l
To evaporate condensation from your interactive flat panel
1. Remove the humidity source from the interactive flat panel, if possible.
2. Adjust the room temperature to normal operating ranges.
3. Turn on the interactive flat panel for 2–3 hours.
If the screen condensation doesn't evaporate, contact SMART Support
(smarttech.com/contactsupport).

Checking the interactive flat panel installation

Inspect your interactive flat panel installation frequently to ensure that it remains securely installed.
Check the mounting location for signs of damage or weakness that can occur over time.
l
Check for loose screws, gaps, distortions or other issues that could occur with the mounting
l
apparatus.
If you find an issue, refer to a professional installer.

Removing your interactive flat panel

To safely remove your interactive flat panel, use two or more professional installers.
I M P O R T A N T
Follow the instructions included with the floor stand or mounting apparatus.
62 smarttech.com/kb/170177