Using A Smart Gowire Cable - SMART Board SBID 8055i User Manual

C H A P T E R 6
Using guest laptops with your interactive flat panel
To connect a guest laptop
1. Connect an HDMI cable from the guest laptop's HDMI input to your interactive flat panel's side
terminal panel.
2. Connect a USB cable from the laptop's USB receptacle to your interactive flat panel's side
terminal panel.
I M P O R T A N T
The USB A receptacle is for USB devices only. Do not connect the guest laptop to this
receptacle.
3. Turn on the laptop.
4. Press the HDMI 2 input button on the remote control.
OR
Press the Input button
To return to using computer 1
1. Press the VGA 1 button on the remote control.
OR
Press the Input button
Press the Input button
2. Disconnect the guest laptop from the interactive flat panel if required.
Using a SMART GoWire cable
Any computer connected to your interactive flat panel requires SMART software. Typically, you
install this software on your room computer so that it's always ready to use.
However, if you want to connect a laptop that doesn't have SMART software installed, you can
connect a SMART GoWire cable from the laptop to the USB cable for your interactive flat panel. The
SMART GoWire cable enables you to have touch control of your laptop and use SMART Meeting Pro
software without installing the software on your laptop.
A SMART GoWire cable is included with SMART Board 8055i-SMP and 8055ie-SMP interactive flat
panels.
52 smarttech.com/kb/170177
on the front control panel until the input source is HDMI 2.
on the front control panel until the input source is VGA.
on the front control panel until the input source is VGA 1.