Grandstream Networks HandyTone-486 User Manual page 28

HandyTone-486 User Manual
Caller Request
Timer
Callee Request
Timer
Force Timer
UAC Specify
Refresher
UAS Specify
Refresher
Force INVITE
Firmware Upgrade
and Provisioning
Firmware Server
Path
Config Server Path
Firmware File
Prefix
Firmware File
Postfix
Config File Prefix
Config File Postfix
Automatic Upgrade Choose "Yes" to enable automatic upgrade and provisioning and input the
Firmware Key
If selecting "Yes" the phone will use session timer when it makes outbound
calls if remote party supports session timer.
If selecting "Yes" the phone will use session timer when it receives inbound
calls with session timer request.
If selecting "Yes" the phone will use session timer even if the remote party
does not support this feature. Selecting "No" will allow the phone to enable
session timer only when the remote party support this feature.
To turn off Session Timer, select "No" for Caller Request Timer, Callee
Request Timer, and Force Timer.
As a Caller, select UAC to use the phone as the refresher, or UAS to use the
Callee or proxy server as the refresher.
As a Callee, select UAC to use caller or proxy server as the refresher, or UAS
to use the phone as the refresher.
Session Timer can be refreshed using INVITE method or UPDATE method.
Select "Yes" to use INVITE method to refresh the session timer.
Default method is HTTP. Firmware upgrade may take up to 10 minutes
depending on network environment. Do not interrupt the firmware upgrading
process.
IP address or domain name of firmware server.
IP address or domain name of configuration server.
Default is blank. If configured, HT486 rev. 2.0 will request the firmware file
with the prefix. This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
number, in minutes, you want the HT to check for an update. When set to No,
HT502 will only do upgrade once at boot up.
Firmware at Boot up" will check for new firmware every time the device
reboots. "Check New Firmware only when F/W pre/suffix changes" will check
for updates only when the pre/suffix has been changed.
For firmware encryption. It should be 32 digit in Hexadecimal Representation.
End user should keep it blank.
28
Grandstream Networks, Inc.
"Always check for New