Grandstream Networks HandyTone-486 User Manual page 21

HandyTone-486 User Manual
Reply to ICMP on
WAN port
Cloned WAN MAC
Address:
LAN Subnet Mask
LAN DHCP Base IP: Base IP for the LAN port, which functions as a gateway for its LAN. Default
DHCP IP Lease
Time
DMZ IP:
Port Forwarding:
In addition to the Basic Settings configuration page, end users also have access to the device Status
page.
MAC Address
WAN IP Address
Product Model
Software Version
System Uptime
Registered
PPPoE Link Up
NAT
Unit will not respond to PING from WAN side if set to "No".
Allow user to set a specific MAC address. Set in Hex format.
Sets the LAN subnet mask. Default value is 255.255.255.0. If bridge mode is
selected, the LAN settings have no effect.
value is 192.168.2.1
The amount of time that a given IP address will be valid for a LAN client.
Value is set in units of hours. Default value is 120hr (5 Days).
Forward all WAN IP traffic to a specific IP address if no matching port is
used by HandyTone-486 itself or in the defined port forwarding.
Allow user to forward a matching (TCP/UDP) port to a specific LAN IP
address with a specific (TCP/UDP) port.
The device ID, in HEX format.
troubleshooting.
This field shows WAN port IP address.
This field contains the product model info, such as HT486 Rev:2.0
Program: This is the main software release. This number is always used for
firmware upgrade. Current release is 1.0.8.32.
Bootloader: current version is 1.0.8.11.
HTML: current version 1.0.8.32.
VOC: current version is 1.0.0.12
This shows how long the device has been up since the last reboot.
This shows whether the unit is registered to service provider's server or not.
This field shows whether the PPPoE connection is up if the HandyTone
ATA is connected to DSL modem.
This shows what kind NAT the HandyTone ATA is connected to via its
WAN port. It is based on STUN protocol.
This is very important ID for ISP
21
Grandstream Networks, Inc.