Grandstream Networks HandyTone-486 User Manual page 11

HandyTone-486 User Manual
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
99 "RESET"
"Invalid Entry"
IVR supports error reporting when the following problems occur. User will hear silence when picking
up the handset. After pressing ***, user will hear one or more error codes listed below. User may hear
one or more error codes depending on errors detected such as E104E103E. Upon hearing error code,
user can press # to get into the IVR main menu.
E101E
E102E
E103E
E104E
E105E
NOTES:
• Once the LED button is pressed, it enters voice prompt main menu. If the button is pressed
again while it is already in the voice prompt menu state, it jumps to "Direct IP Calling" option
and dial tone plays in this state
•
"*" shifts down to the next menu option
• "#" returns to the main menu
• "9" functions as the ENTER key in many cases to confirm an option
• All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP
address. Once all digits are accumulated, the device will automatically process them
• For IP address input, omit the dot and enter the digits directly, add 0 for those octets with less
than three digits. e.g.: IP: 192.168.1.10, key in: 192168001010
• Key entry cannot be deleted but the phone may prompt error once it is detected
Ethernet link down
No IP address obtained (DHCP or PPPoE mode)
Device is not registered to SIP server
Provisioning in action
No STUN responses
Firmware version information.
Firmware upgrade mode. Enter "9" to rotate
among the following three options:
- always check
- check when pre/suffix changes
- never upgrade
When entered, user will be prompted a dial
tone, dial a 12-digit IP address to make a direct
IP call.
(For details, see "4.2.2 Make a Direct IP
Call".)
Enter "9" to reboot the device; or
Enter MAC address to restore factory default
setting (For details, see section 8.)
Automatically returns to Main Menu
11
Grandstream Networks, Inc.