Grandstream Networks HandyTone-486 User Manual page 19

HandyTone-486 User Manual
The password is case sensitive with a maximum length of 25 characters. The factory default password
for End User and administrator is "123" and "admin" respectively. Only administrator can get access
to "ADVANCED SETTINGS" configuration page.
NOTE:
• If you can not log into the configuration page by using the default password, please check with
your VoIP service provider. Most likely, the service provider has provisioned the device and
configured for you and changed the default password.
After the correct password is entered into the login screen, the embedded Web server inside the device
will respond with a BASIC SETTINGS configuration page.
End User
Password
Web Port
IP Address
DHCP hostname
DHCP domain
DHCP vendor class
ID
PPPoE account ID
PPPoE password
This field contains the password to access the Web Configuration Menu. The
password is case sensitive with a maximum of 25 characters.
This is the device's internal HTTP server port. Default is 80.
There are 2 modes under which the HandyTone ATA can operate:
- If DHCP mode is enabled, then all the field values for the Static IP mode are
not used (even though they are still saved in the Flash memory) and the IP
phone will acquire its IP address from the first DHCP server it discovers on
the LAN it attaches to.
To use PPPoE feature please set the PPPoE account settings if the HandyTone
ATA is connected directly to a DSL modem. The HandyTone ATA will
attempt to establish a PPPoE session if any of the PPPoE fields are set.
- If Static IP mode is selected, then the IP address, Subnet Mask, Default
Router IP address, DNS Server 1 (primary), DNS Server 2 (secondary) fields
will need to be configured. These fields are set to zero by default.
This option specifies the name of the client. This field is optional but may be
required by some Internet Service Providers. Default is blank.
This option specifies the domain name that client should use when resolving
hostnames via the Domain Name System. Default is blank.
This option is used by clients and servers to exchange vendor-specific
information. Default is blank.
PPPoE username. Fill this field if your ISP requires you to use a PPPoE
(Point to Point Protocol over Ethernet) connection.
PPPoE account password.
19
Grandstream Networks, Inc.