Location And Mounting Requirements; Installing The Gateway Router; Mounting The Gateway Router; Connecting Cables - Patton electronics SmartNode 4520 Series Getting Started Manual

3 • Hardware installation

Location and mounting requirements

The SmartNode router is intended to be placed on a desktop or similar sturdy, flat surface that offers easy
access to the cables. Allow sufficient space at the rear of the chassis for cable connections. Additionally, you
should consider the need to access the unit for future upgrades and maintenance.

Installing the gateway router

SmartNode gateway router installation consists of the following:
• Placing the device at the desired installation location (see section
page 38)
• Installing the interface and power cables (see section
When you finish installing the SmartNode, go to chapter 4,

Mounting the gateway router

Place the router on a desktop or similar sturdy, flat surface that offers easy access to the cables. The router
should be installed in a dry environment with sufficient space to allow air circulation for cooling.
Note

Connecting cables

Installing router cables takes place in the following order:
1. Installing the RJ-11 voice port (FXS) cable or cables (see "Installing an interface cable on the router's FXS
and FXO interface ports")
2. Installing the 10/100 Ethernet port cable or cables (see
3. Installing the power input (see
38
VoIPon www.voipon.co.uk
For proper ventilation, leave at least 2 inches (5 cm) to the left, right, front,
and rear of the SmartNode gateway router.
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
"Connecting to external power source"
sales@voipon.co.uk
Model 4520 & 4110 Series Getting Started Guide

"Mounting the gateway router"

"Connecting cables"

on page 38)
"Getting started with the SmartNode"
"Installing the Ethernet cable"
on page 43)
Tel: +44 (0)1245 808195
on
on page 45.
on page 41)

Installing the gateway router

Fax: +44 (0)1245 600030