Ports Descriptions - Patton electronics SmartNode 4520 Series Getting Started Manual

1 • General information

Ports descriptions

The SmartNode 4520 Series rear panel ports are described in
Port
10/100 Ethernet
ETH 0/0 & ETH 0/1
Analog voice port,
FXS
Analog voice port,
FXO
Power
Console
Reset button behavior
For those SmartNode devices that have a Reset button on the rear panel, its behavior is as follows:
• To restart the unit with the current startup configuration—Press for less than 1 second and release the Reset
button. The SmartNode will restart with the current startup configuration.
• To restart the unit with factory default configuration—Press the Reset button for 5 seconds until the Power
LED starts blinking. The unit will restart with factory default configuration.
• To restart the unit in bootloader mode (to be used only by trained SmartNode technicians)—Start with the
unit powered off. Press and hold the Reset button while applying power to the unit. Release the Reset button
when the Power LED starts blinking so the unit will enter bootloader mode.
18
VoIPon www.voipon.co.uk
Table 2. Rear panel ports
Location
Rear panel RJ-45 connectors (see
Ethernet device (e.g., a cable or DSL modem, LAN hub or switch).
Rear panel FXS RJ-11(6 position, 4 wire) connectors (see
connect the router with an analog terminal (a telephone, for example)
FXO port. EuroPOTS support (ETSI EG201 188). FXS on-hook voltage is
48V for each FXS port.
Rear panel FXO RJ-11(6 position, 4 wire) connectors (see
connect the router with an analog line (FXS port). EuroPOTS support (ETSI
EG201 188).
Rear panel The gateway is available in a DC or AC power input version (see
), labeled as follows:
figure 3
AC version (Internal power supply): 100–240 VAC, 50/60 Hz, 200 mA
•
DC version: 12 VDC, 1.25 A
•
Front panel Used for service and maintenance, the Console port (see
an RS-232 RJ-45 connector, connects the router to a serial terminal such as a PC
or ASCII terminal (also called a dumb terminal).
sales@voipon.co.uk
Model 4520 & 4110 Series Getting Started Guide
table 2.
Description
on page 39) that connect the router to an
figure 16
figure 16
figure 16
SmartNode Series VoIP routers overview
Tel: +44 (0)1245 808195
on page 39) that
on page 39) that
on page 19),
figure 4
Fax: +44 (0)1245 600030