Table of Contents
Advertisement
Step 8: Attach Lower Covers
A.
Remove the screw (24a) from each of the right (12) and left (8) support post covers.
B.
Remove screw (24b) from the inside of the motor compartment on both sides.
C.
Loosen the four screws (26) on the bottom of the frame. Two on each side.
D.
Slide the right upright cover (12) into place. Install the screw (24b) on the inside of the motor compartment
that was removed in step 8-B. Install screw (24a) that was removed in step 8-A.
E.
Tighten the two screws (26) on the bottom of the frame from step 8-C.
F.
Repeat steps 8-D and 8-E for left upright cover (8).
G.
Once the two upright covers are installed, reinstall the motor cover that was removed in step 2 by placing
the motor cover (6) so the four screws (27) slide into the cutouts in the cover. Then tighten the screws.
Note:
To tighten the four screws (26) on the bottom of the frame, it may be easier to start the treadmill
and raise the incline. This will give more space to get to the screws.
24b
24a
8
18
27
27
26
27
6
12
27
Hide quick links:
Advertisement
Table of Contents
