Table of Contents
Advertisement
Step 3: Support Post Assembly
A.
Remove the three bolts (14) and washers (15) from the bottom of the left upright (4).
B.
Place the U shaped bracket on the bottom of the support post onto the main frame of the unit. Align the
three holes in the bracket with the holes in the frame. Install the three bolts (14) and washers (15) removed
in step 3-A. Do not tighten at this time.
C.
Remove the three bolts (14) and washers (15) from the bottom of the right upright (5). Make sure the cable
(16) is not in the U-shaped bracket.
D.
Place the U-shaped bracket on the bottom of the right support post (5) onto the main frame. Align the three
holes in the bracket with the holes in the frame. Install the three bolts (14) and washers (15) removed in step
3-C. Do not tighten at this time.
Note:
Move cables 16 and 17 so they do not get pinched or damaged when installing upright.
E.
Connect cable (16) coming from the bottom of the right support post to cable (17) coming from the
motor control board.
4
15
14
12
5
16
17
4
Hide quick links:
Advertisement
Table of Contents
