First Start-Up And Calibration - Husqvarna AUTOMOWER 305 Operator's Manual

3.8 First start-up and calibration

Before the mower is operated, a start-up sequence in
the mower's menu must be carried out as well as an
automatic calibration of the guide signal. The
calibration is also a good test to see that the installation
of the guide wire has been done in such a way that the
mower can easily follow the guide wire from the
charging station.
1. Set the main switch to the 1 position.
2. Open the control panel cover by pressing the
STOP button.
A start-up sequence begins when the Automower
is started for the first time. The following is
requested:
• Language
• Time format
• Current time
• Date format
• Date
• Four digit PIN code. All combinations except
0000 are permitted.
IMPORTANT INFORMATION
Use Memo on page 4 to make a note of the
PIN code.
3. Place the mower in the charging station as
requested in the display. The mower will now start
the guide calibration, by leaving the charging
station and following the guide wire to the point
where the guide wire is connected to the boundary
wire to begin mowing there. Check that the mower
can follow the guide wire all the way. If it cannot,
this may be due to an incorrectly installed guide
wire. In this case, check that the installation is
performed as described in chapter 3.6 Installation
of the guide wire on page 28.
32 - English
3. INSTALLATION
®