Test Docking With The Charging Station - Husqvarna AUTOMOWER 305 Operator's Manual

3.9 Test docking with the charging station

Before using the mower, check that it can follow the
guide wire all the way to the charging station and easily
docks with the charging station. Perform the test below.
1. Open the control panel cover by pressing the
STOP button.
2. Place the mower close to the point where the
guide wire is connected to the boundary wire.
Place the mower about 2 metres from the guide
wire, facing the guide wire.
3. Select Home mode by pressing the house symbol
key and pressing OK when the cursor is at Home.
Press Start and close the cover.
4. Check that the mower follows the guide wire all
the way to the charging station and that it docks
with the charging station. The test is approved
only if the mower is able to follow the guide wire
the entire distance to the charging station and
docks at the first attempt. If the mower is unable to
dock on the first attempt, it will automatically try
again. The installation is not approved if the
mower needs two or more attempts to dock with
the charging station. In this case, check that the
charging station, the boundary wire and the guide
wire are installed in accordance with the
instructions in Chapters 3.2, 3.4 and 3.6.
5. The mower will stay in the charging station until
Auto or Man mode is selected. See 5.1 Operation
selection on page 39.
The guide system must first be calibrated if the above
test is to provide a satisfactory result. See 3.8 First
start-up and calibration on page 32.
3. INSTALLATION
English - 33