Automower ® Intelligent Mapping (Aim); To Start The Product For The First Time - Husqvarna AUTOMOWER 535 AWD Operator's Manual

3.10.3 Download firmware over the air
(Firmware over the air FOTA)
The product has a function that automatically downloads
new firmware. When a new firmware is available, a
notification shows in the app where you can select
to install the new firmware. In the factory setting this
function is enabled.
®
3.10.4 Automower Direct
®
Automower Direct uses short-range Bluetooth
communication, and is included in Automower
AWD.
Husqvarna cannot guarantee the time period or
coverage of the long-range cellular connectivity. It is
possible to communicate with the product through
®
Bluetooth if you are in short-range of the product.
You can use Automower ® Direct without a Husqvarna
account as long as you have the product PIN code.
3.10.4.1 To start to use Automower
1. Download the Automower
mobile device.
2. Select Automower ® Direct on the start screen of
®
the Automower Connect app.
®
3. Start Bluetooth on your mobile device and on the
To start the product for the first
product, refer to
time on page 19 .
Settings symbol in the display and
4. Go to the
®
activate Bluetooth .
5. Select the product to pair with in the Automower
Connect app.
6. Enter the PIN code for the product.
Note:
You have access to the menus and functions as
®
long as you are in Bluetooth
®
3.11 Automower Intelligent Mapping
(AIM)
®
Automower Intelligent Mapping (AIM) is available in
the Automower ® Connect app. The technology uses
different sensors, GPS included, in the product. The
precision of the map is approximately m / ft.
1427 - 009 - 20.12.2022
®
® 535
®
Direct
®
Connect app on your
®
short-range.
B
A
Some of the functions with AIM are:
• It shows a map of the lawn in Automower
Connect app with charging station, boundary wire,
guide wire and islands.
• You can make work areas (A) and (B) in the
installation where you can set a schedule and
cutting height for each work area.
• You can make stay-out zones (C) in which the
product cannot enter and cut grass.
Note:
With the AIM function you can set work areas
and stay-out zones with a precision of approximately m /
ft.
The data collection for the AIM map starts automatically.
The product collects data while it operates and the
map is completed in 1-2 weeks. Remove temporary
obstacles on the lawn when the product operates and
collects data. If you change the installation of the wires
or charging station, you must do a new map. Read more
®
about AIM in the Automower
3.12 To start the product for the first
time
When the product is set to ON for the first time, there
are some basic settings to do before the product can
start to operate.
1. Push the ON/OFF button for 3 seconds to set the
product to ON.
Note:
®
The Bluetooth
of the product is enabled for 3 minutes. If the
pairing operation between the product and the
mobile device is not completed in 3 minutes, set
the product to OFF and then set the product to ON.
2. Enter the factory PIN code.
3. Log on to your Husqvarna account in the
®
Automower Connect app.
®
4. Start Bluetooth on your mobile device.
C
®
Connect app.
pairing operation mode
Installation - 19