Checking The Installation; First Start-Up And Calibration; Test Docking With The Charging Station; Control Panel - Husqvarna AUTOMOWER 440 Operator's Manual

9. Staple down or bury the splice in the lawn.
CAUTION: The guide wire may not cross the
boundary wire, for instance a boundary wire that
is laid out to an island.

3.8 Checking the installation

Check the loop signal by inspecting the indicator lamp
on the charging station.
Indicator lamp in the charging station on page 54 if
See
the lamp does not indicate a solid or flashing green light.

3.9 First start-up and calibration

When the main switch is set to position
time, a start-up sequence in the robotic lawnmower's
menu must be carried out as well as an automatic
calibration of the guide signal.
1. Open the hatch by pressing the STOP button.
2. Set the main switch to position
A start-up sequence begins when the robotic
lawnmower is started for the first time. The following
is requested:
447 - 001 -
1 for the first
1 .
• Language.
• Country
• Date
• Time
• Selection and confirmation of personal PIN code.
All combinations except 0000 are permitted.
MEMO page at the beginning of the
Note: Use the
manual to make a note of the PIN code.
3. Place the robotic lawnmower in the charging station
and press START. The robotic lawnmower will now
begin to calibrate the guide wire.
Press START and close the hatch. The calibration is
performed by the robotic lawnmower backing out of
the charging station and running a calibration
process in front of the charging station. When this is
completed, mowing can begin.

3.10 Test docking with the charging station

Before using the robotic lawnmower, check that the
robotic lawnmower can follow the guide wire all the way
to the charging station and easily docks with the
charging station.
The test function is found in the robotic lawnmower's
Installation > Find charging station > Guide > More >
Test guide menu. For more information, see Boundary >
More > Test right / Test left on page 30 .
If no guide wire is installed the test must be carried out
on the boundary wire, both clockwise and anti-
clockwise.
The guide system must first be calibrated if the above
test is to provide a satisfactory result.

3.11 Control panel

3.11.1 Instruction - Control panel
All commands and settings for the robotic lawnmower
are made via the control panel. All functions are
accessed via a number of menus.
The control panel consists of a display and a keypad. All
information is shown on the display and all input is done
using the buttons.
3.11.2 Keypad
The keypad consists of 6 groups of buttons:
• The START button is used to activate the robotic
lawnmower. This is normally the last button to be
pressed before closing the hatch.
• The BACK and OK buttons are used to navigate in
the menu. The OK button is also used to confirm
settings.
Installation - 21