Symptom - Husqvarna AUTOMOWER 305 Operator's Manual

9.3 Symptom

If your Automower does not work as expected, follow the troubleshooting guide below.
®
There is a FAQ (Frequently Asked Questions) on www.automower.com which provides more detailed
answers to a number of standard questions. It you still cannot find the reason for the fault, contact the local
dealer.
Symptom
The robotic lawn
mower has difficulty
docking with the
charging station
Uneven mowing
results
Automower runs at
®
the wrong time
9. TROUBLE SHOOTING
Cause
The boundary wire is not laid in a long
straight line that is far enough out
from the charging station.
The guide wire is not inserted in the
slot at the bottom of the charging
station.
The charging station is on a slope
Automower ® works too few hours per
day.
The proportion setting is incorrect in
relation to the layout of the working
area
Working area too large.
Dull blades.
Long grass in relation to the set
cutting height.
Accumulation of grass by the blade
disc or around the motor shaft.
The clock on Automower
be set.
The start and stop times for mowing
are incorrect.
Action
Check that the charging station has
been installed according to the
instructions in 3.2 Installation of the
charging station on page 16.
It is absolutely critical for operation
that the guide wire is perfectly straight
and is in the correct position under
the charging station. Therefore make
sure that the guide wire is always in
its slot in the charging station. See
3.6 Installation of the guide wire.
Place the charging station on a
surface that is entirely level. See
3.2 Installation of the charging station
on page 16.
Increase the mowing time, see
6.3 Timer (1) on page 43.
Check that the correct Proportion
value is selected. See 6.4 Installation
(2) on page 44.
Try limiting the working area or
extending the working time, see
6.3 Timer (1) on page 43.
Replace all the blades and screws so
that the rotating parts are balanced.
See 8.7 Blades on page 56.
Increase the cutting height and then
successively lower.
Check that the blade disc rotates
freely and easily. If not, screw off the
blade disc and remove grass and
foreign objects. See 8.4 Cleaning.
needs to Set the clock, see 6.6 Settings (4) on
®
page 49.
Reset the start time and stop time
settings for mowing, see 6.3 Timer (1)
on page 43.
English - 63