Table of Contents
Advertisement
MLP 101 D
About the MLP 101 D
The Extron MLP 101 D provides the same features as the other
MLP 101 models in a convenient, Decora
the MLP 101 and MLP 101 AAP, this mic to line preamplifier
can be remotely controlled via a VCM volume/mute control
module. The MLP 101 D does not provide a mute button.
Rear Panel Features
1
2
3
4
5
Power input
a
Power — Plug the external 12 VDC power supply into this
captive screw connector. The power supply is included with the
unit.
T
To verify the polarity before connection, plug in the power
supply with no load and check the output with a voltmeter.
C
When connecting the power supply, voltage polarity
is extremely important. Applying power with
incorrect voltage polarity could damage the power
supply and the interface. Identify the power cord
negative lead by the ridges on the side of the cord.
MLP 101 Series • MLP 101 D
4-2
®
style wall plate. Like
Smooth
Ridges
A
A
SECTION A–A
Power Supply
Output Cord
N
Do not tin the stripped power supply leads before
installing the captive screw connector. Tinned wires are
not as secure in the captive screw connectors and could
pull out.
W
The two power cord wires must be kept separate while
the power supply is plugged in. Remove power before
continuing.
Audio output (line level)
b
Phantom power switch — Provides switchable 48 volt phantom
power for condenser microphones.
c
Line Output — A 3-pin, captive screw connector outputs to
audio mixers, amps switchers, or other non-microphone audio
equipment.
0.2"
(5 mm) MAX
Captive Screw
Connector stripping
Tip
Ring
Sleeve
Balanced Output
d
Low Cut filter switch — Provides low cut filtering to remove
wind and "table rumble" noise.
MLP 101 Series • MLP 101 D
0.2" (5 mm) MAX
Captive Screw
Connector
CAUTION
For unbalanced audio, connect the sleeve(s)
DO NOT
to the ground.
connect the sleeve(s)
to the negative (-) contact.
Tip
NO Ground Here
Sleeve
Unbalanced Output
(high impedance)
4-3
Advertisement
Table of Contents
