Using Opp; Pairing With An Opp Device; Remote Device Pushes File To Vx6 - Honeywell vx6 Reference Manual

Using OPP

Pairing with an OPP Device

Prerequisites
A remote device, such as a mobile phone, that supports OPP.
l
OPP is enabled on the VX6.
l
How To
1. Place the remote device in discovery or visible mode.
2. Initiate discovery on the VX6 by tapping the Discover button on the OPP Send tab.
3. The VX6 discovers the remote device.
4. The VX6 attempts to send a file to the remote device.
5. The remote device prompts the user for a 4 digit PIN.
6. User enters the PIN.
7. The VX6 prompts the user for a 4 digit PIN.
8. User must enter the same PIN code as entered on the remote device.
9. The VX6 now pairs with the remote device.

Remote Device Pushes File to VX6

This section assumes that a device supporting OPP is paired with the VX6.
If a duplicate filename is received, LXEZ Pairing writes the file in the specified location, with an incremental number appended
to the file name. For example, if a file named file.jpg is pushed to the VX6 and that filename already exists in the Inbox, LXEZ
Pairing saves the new file as file001.jpg. If the same file is pushed again, it is saved as file002.jpg.
There are several scenarios based on configuration options on the OPP Setup tab.
Notifications enabled, VX6 is Write Capable
1. The OPP client initiates a connection to the VX6 by selecting a file to push to the VX6.
2. The VX6 user is notified that a File Push request has been issued from a remote device.
3. The VX6 user is prompted to accept or reject the incoming request.
4. If the user accepts the request:
a. The file is pushed to the VX6.
b. LXEZ Pairing notifies the user that a file has been received.
c. The connection is closed by the remote device (OPP client).
5. If the user rejects the request:
a. The file is not pushed to the VX6.
b. The connection is closed.
Notifications enabled, VX6 is not Write Capable
3-79